Konica Minolta bizhub 361 - Manual (Page 140)

501/421/361 3-7
User Operations 3
12
Enter the 8-digit Account Password from the keyboard or keypad.
– Press the [C] key to clear all characters.
– Touch [Delete] to delete the last character entered.
– Touch [Shift] to show the upper case/symbol screen.
– Touch [Cancel] to go back to the screen shown in step 11.
13
Touch [OK].
14
Press [Access] or touch [Login]. If documents are stored in the ID & Print User Box, the login method
selected in step 7 will appear. Select the login method displayed on the screen.
? What if a wrong Account Name or Account Password is entered?
% If a wrong Account Name is entered, a message appears that tells that authentication has not been
successful. The machine then prohibits entry for Account authentication for 5 sec. and then causes
the screen of step 1 to reappear. Perform Account authentication once again.
% If there is a mismatch of Account Password relative to the registered Account Name, a message
appears that tells that authentication has not been successful. The machine then prohibits entry of
Account Name and Account Password for 5 sec. and then causes the screen of step 11 to reappear.
Enter the correct Account Password.
% If the Enhanced Security Mode is set to [ON], the entry of a wrong Account Password is counted as
unauthorized access. If a wrong Account Password for the corresponding Account Name entered
is entered a predetermined number of times (once to three times) set by the Administrator of the
machine or more, a message appears that tells that authentication has not been successful for any
subsequent operation for authentication. The machine is then set into an access lock state, rejecting
any more logon attempts. To cancel the access lock state, the Administrator of the machine must
perform the Release Setting. Contact the Administrator of the machine.
15
Pressing the [Access] key will show the following screen.
Select [Yes] and touch [OK] to log off from the user operation mode.