Konica Minolta bizhub PRESS C1085 - Manual (Page 17)

bizhub PRESS C1100/C1085 (IC-602) 2-5
2.1 Turning the Power ON/OFF 2
Power saving function
Using the following functions can reduce the power consumption of this machine and provide greater power
saving effects.
Tips
- Utility/Counter - [Administrator Setting] - [System Setting] - [Power Save Setting] - [Power Save Func-
tion Setting] is the same as Utility/Counter - [User Setting] - [System Setting] - [Power Save Setting] -
[Power Save Function Setting]: use either of the methods to configure a setting.
- If Power Save on the control panel is pressed for one second or more, either of Auto Low Power and
Auto Shut OFF is enabled. To enable either function, select [Administrator Setting] - [System Setting] -
[Power Save Setting] - [Power Save Function Setting].
d
Reference
For details, refer to the [HTML User's Guide].
NOTICE
In the Auto Shut OFF mode, only jobs from [PageScope Direct Print (PSDP)] can be printed out. To use other
jobs, check that this machine can be used normally.
If this machine is turned off because the Weekly Timer has started, job data is not received even if it is sent.
While this machine can be used normally, send job data again.
Function Description
Power Save
function Auto Low Power Turns off the touch panel display to reduce the power con-
sumption of this machine. This machine is placed into the Auto
Low Power mode when:
•
The specified period of time has elapsed with no print jobs
executed in the printable state
• Power Save on the control panel has been pressed for a
second or more
This mode is available when [Auto Low Power] is selected by
selecting Utility/Counter - [Administrator Setting] - [System
Setting] - [Power Save Setting] - [Power Save Function Set-
ting].
There are eight power saving time periods available: 5, 10, 15,
30, 60, 90, 120, and 240 minutes, from which you can select
the desired one.
Power saving time periods, 90, 120, and 240 minutes, may not
be displayed depending on regions.
Auto Shut OFF Turns off all LEDs except Power Save and Power on the con-
trol panel, to reduce the power consumption of this machine.
This machine is placed into the Auto Shut OFF mode when:
•
The specified period of time has elapsed with no print jobs
executed in the printable state
• Power Save on the control panel has been pressed for a
second or more
If the Auto Shut OFF mode is kept for a long time, it may take
a while to warm up this machine upon restart.
This mode is available when [Auto Shut OFF] is selected by se-
lecting Utility/Counter - [Administrator Setting] - [System Set-
ting] - [Power Save Setting] - [Power Save Function Setting].
There are seven power saving time periods available: 0, 1, 30,
60, 90, 120, and 240 minutes, from which you can select the
desired one.
ErP Setting Turns the main power off after the Auto Low Power mode, Auto
Shut OFF mode, or the sub power switch is kept in the off
state for the specified period of time.
There are six power saving time periods available: Do Not
Switch,12, 24, 36, 48, 60, and 72 Hours, from which you can
select the desired one.
If the Weekly Timer is set to [Weekly Timer ON], [ErP Setting]
appears dimmed and you cannot configure this setting.
Weekly Timer Automatically turns the power of this machine on or off based
on the specified time or day of the week.