Konica Minolta bizhub PRESS C1085 - Manual (Page 39)

bizhub PRESS C1100/C1085 (IC-602) 5-3
5.1 Loading Paper 5
5 Basic Operations
5.1 Loading Paper
5.1.1 Loading paper into the Paper Feeder Unit PF-708
The following describes how to load paper into an optional Paper Feeder Unit PF-708. The same paper load-
ing procedure is used for Paper Feeder Units PF-707 and Paper Feeder Units PF-708. The same paper
loading procedure is used for each tray.
1
Pull out the tray to load paper into.
NOTICE
Trays can be pulled out only when this machine is turned on.
Before pulling out the target tray, check that the sub power
switch is turned on.
In order to prevent the machine from falling down, only one
tray can be pulled out at a time.
2
Turn the side guide lock knobs (2 pieces) counterclock-
wise to loosen them.
3
While pressing the side guide lock release lever ( ),
slide the side guide plates to any positions ( ).
% Determine their locations based on the size indicator of
the bottom plate of the tray.
NOTICE
To slide the side guide plates, be sure to hold both side
guide plates together. If you move it by holding only either
of the side guide plate, the side guide plate that held may
become displaced.
4
While pressing the rear guide lock release lever, slide the
rear guide plate to any positions.
% Determine their locations based on the size indicator of
the bottom plate of the tray.
5
To fix the side guide plates at the correct locations, load an appropriate amount of paper into the tray
while aligning it to the left-hand side of the tray.
NOTICE
Load paper with the print side facing up.
6
Press the side guide plates against paper, then turn the side guide lock knobs (2 pieces) clockwise
to fix them.