Konica Minolta PAGEPRO 9100 - Manual (Page 91)

Solving Problems 85
Other Problems
Symptom Cause Solution
Printer
power is
not on.
The power cord is not
correctly plugged into
the outlet. Set the power switch off (O position),
then remove the power cord from the out-
let and plug it back in, then set it back to
the on (I) position.
The power switch
has not been
pressed. Set the power switch to the on (I) posi-
tion.
The power switch is
not correctly turned
on (I position). Set the power switch to the off (O) posi-
tion, then set it back to the on (I) position.
Something is wrong
with the outlet you
are using for the
printer. If the outlet is connected to a switch, turn
on the switch.
Plug another electrical appliance into the
outlet and see whether it operates prop-
erly.
The printer is con-
nected to an outlet
with a voltage or fre-
quency that does not
match the printer
specifications. Use a power source with the specifica-
tions listed in appendix A, “Technical
Specifications.”
“Printer is not
responding”
is displayed
in the Print
Monitor. The printer is in
energy-saving mode. It takes a little time for printing to start if
the printer is in energy-saving mode. You
can change the number of minutes
before the printer switches to power-sav-
ing mode in the Administration/Engine/
Energy Saver menu. If you do not want to
use this mode, disable it in the Adminis-
tration/Engine/Energy Saver menu.
Printer resets
or turns off
frequently.
The power cord is not
properly connected
to the AC outlet. Turn off the unit, confirm that the power
cord is properly connected to the AC out-
let, and turn the unit back on.
A system error
occurred. Contact Technical Support with the error
information. See the Service & Support
Guide for support telephone numbers.