Konica Minolta Bizhub 215 - Manual (Page 60)

bizhub 215 2-7
2.5 Making copies on envelopes 2
Us
ing
as
a C
opy
Ma
ch
ine
Ch
apte
r 2
2.5 Making copies on envelopes
You can load envelopes into the Bypass Tray and Tray 1. As an example, this section describes procedures
for loading envelopes into the Bypass Tray and copying the original onto the envelopes.
1
Press Copy and load the original.
% For details on how to load the original, refer to page 1-37.
2
Load envelopes into the Bypass Tray.
% Load the envelopes with the flap side facing up, so that the side on which you want to copy the
original is facing down.
% Up to 10 envelopes can be loaded into the Bypass Tray. Do not load the envelopes up to the point
where the top of the stack is higher than the + mark.
% When envelopes are loaded into the Bypass Tray, a screen for specifying the paper appears on the
Control Panel. Go to Step 3 to configure the settings.
3
Configure the settings for the envelopes.
% Use +, to select [SIZE], then press ). (1)
% Use +, to select the correct setting, then press OK. (2)
% Use the Keypad to specify the envelope size, then press OK. (3)(4)
% Use +, to select [TYPE ], press ) and select [ENVELOPE]. (5)(6)
% Press Back to return to the basic screen.
% If you are not sure about the size of the envelopes, measure the X and Y lengths using the Original
Scale.
4
Use the Keypad to specify the number of copies, then press Start.
d
Reference
For details on configuring the settings for paper in Tray 1, refer to Chapter 6 of the [User's Guide Copy Op-
erations].