Konica Minolta KIP C7800 - Manual (Page 4)

KIP System Setup & Installation
This information is solely for use of KIP Personnel and KIP Authorized Dealers. No part of this publication may be copied,
reproduced or distributed in any form without express written permission from KIP. © 2011 KIP.
- 1 -
Basic Setup - LAN Connection
The KIP IPS is setup to look for DHCP settings when plugged into the site network. However if the network
does not support DHCP or if the IT Administrator would rather set a static IP Address the following
procedure will walk them through the setup.
Please follow these steps completely:
1. Start up IPS
2. From the IPS Home Screen, select the “?” button.
3. Select the “Configuration 2” button
4. Using the Arrow buttons at the bottom scroll to page
3 of 4
5. Select the “Network” button
6. Obtain the Network information from the IT Administrator to set
up a static IP Address (Obtain the IP address Automatically
(DHCP) is set by default).
7. Select “Apply”
8. Select “OK”
9. Select the “?” button to confirm IP
Address has been set