Konica Minolta bizhub PRESS 2250P - Manual (Page 124)

Parameter Option Description
Signature
marks Mode Enables you to print a mark on the front or back of a folded
signature. Signature marks help in assembling printed signatures
for binding in the correct order.
Provides the following options:
● Off—Signature marks are not selected.
● Auto—Automatically calculates the position and offset of the
mark. Enables you to determine the amount of black toner used
for printing the signature mark.
● Custom—Enables you to define the signature marks for printing
according to front, back, height, width, type, and the number of
marks.
First Mark
Position
Note: This option is available only when the signature mark mode is
set to Custom.
Enables you to specify the position of the first signature mark.
Mark Offset
Note: This option is available only when the signature mark mode is
set to Custom.
Enables you to specify the offset between signature marks.
Black Color Enables you to determine the amount of black toner used for
printing signature marks.
Spacing Margins Determines the space between the edge of the pages and the edge
of the sheet on which the pages are printed.
Notes:
● Margin settings should suit the finishing equipment and
requirements.
● Confirm the binding parameters with your binder when planning
your sheet.
Horizontal
gutter Determines the horizontal space between pairs of pages (according
to the trim size) on a sheet. When the pages are folded into a
booklet, the gutter allows space for trimming.
The value that you enter depends on the paper size and imposition
method that you choose.
Vertical gutter Determines the vertical space between pairs of pages (according to
the trim size) on a sheet. When the pages are folded into a booklet,
the gutter allows space for trimming.
The value that you enter depends on the paper size and imposition
method that you choose.
116 Chapter 9—Job parameters