Konica Minolta Magicolor 3300DN - Manual (Page 187)

Regulatory Compliance 179
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
A shielded cable is required to comply with the limits for a Class B dig-
ital device, pursuant to Part 15 of the FCC Rules.
Attention
Any modifications or changes to this product not expressly approved in
writing by the manufacturer responsible for compliance to Federal
Regulations could void the user's authority to operate this product
within the Laws and Regulations of the Federal Communications
Commission.
Canadian Users Notice
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
CE Marking (Declation of Conformity)
This product complies with the following EU directives: 89/336/EEC, 73/23/
EEC, and 93/68/EEC directives.
This declaration is valid for the areas of the European Union (EU) only.
This device must be used with a shielded parallel interface cable and
shielded USB interface cable.
The use of non-shielded cables is likely to result in interference with radio
communications and is prohibited under 89/336/EEC rules.