Konica Minolta bizhub C754 - Manual (Page 70)

bizhub C754/C654 2-54
2.11 Changing the Administrator Password 2
<From PageScope Web Connection>
0 For the procedure to access the Admin Mode, see page 2-2.
0 Do not leave the machine with the Admin Mode setting screen left shown on the display. If it is abso-
lutely necessary to leave the machine, be sure first to log off from the Admin Mode.
1
Start PageScope Web Connection and access the Admin Mode.
2
Click the [Security] tab.
3
Click [Administrator Password Setting] from the menu.
4
Select the "Password is changed" check box. Enter the currently registered Administrator Password
and a new Administrator Password. Then, to make sure that you have entered the correct new pass-
word, enter the new Administrator Password once again.
5
Click [OK].
% If a wrong Administrator Password is entered in the "Current Administrator Password" box, a mes-
sage that tells that the Administrator Password does not match appears. Enter the correct Admin-
istrator Password.
% If the Enhanced Security Mode is set to [ON], entry of a wrong password is counted as unauthorized
access. If a wrong Administrator Password is entered a predetermined number of times (once to
three times) or more set by the administrator of the machine, the Utility screen appears and the ma-
chine is set into an access lock state.
To cancel the access lock state, settings must be made by the Service Engineer; or, turn off, and
then turn on, the main power switch of the machine. If the main power switch is turned off and on,
the access lock state is canceled after the lapse of time set for [Release Time Settings]. When the
main power switch is turned off, then on again, wait at least 10 seconds to turn it on after turning it
off. If there is no wait period between turning the main power switch off, then on again, the machine
may not function properly.
Here is the sequence, through which the main power switch and sub power key are turned on and
off:
Turn off the sub power key ö Turn off the main power switch ö Turn on the main power switch ö
Turn on the sub power key
% If the entered Administrator Password in the "New Administrator Password" box does not meet the
Password Rules, a message that tells that the entered Administrator Password cannot be used ap-
pears. Enter the correct Administrator Password. For details of the Password Rules, see page 1-9.
% If the entered Administrator Password in the "New Administrator Password" box and "Re-type New
Administrator Password" box does not match, a message that tells that the Administrator Password
does not match appears. Enter the correct Administrator Password.
6
Click [OK].