Konica Minolta KIP 600 Scanner - Manual (Page 85)

Section 3 Copy Mode – Color 3-18
2.8. Start
The copier is always set to “Auto Start”. That is when an original is
inserted into the KIP 600, it will start without user intervention.
The start button is used when a job is recalled. The start button will “start”
the job if depressed after ‘Recall” (the name will change to “Re-print”).
2.9. View Last
The last documented scanned to be copied be viewed.
2.10. Recall Job
No function in Color Copy Mode.
2.11. Stop / Reset
This button has two functions.
1) Press the Stop button to stop the current scan. The original will be
ejected automatically. If not, open Top Cover to remove the original.
2) Press the Reset button to restore the “default settings” in Copy
Mode. Some of the default settings are determined in the
Information / Help Screen of the UI. (see Copy Mode
Configurations chapter)
2.12. Interrupt
No function in Color Copy Mode.
2.13. Rescan
No Function in Color Copy Mode.
2.14. Log Off
This button only appears when “Accounting” functions are enabled. This
allows the current user to cease all KIP functions after the user has
preformed the required copies (after the code was entered to enable
Coping).
Please note that the KIP printer will also automatically log off the current user after 180
seconds of no copy function activities by a user.