Konica Minolta magicolor 1680MF - Manual (Page 45)

Print Media 3-4
„ Layered
„ Adhesive
„ Folded, creased, curled, embossed, warped, or wrinkled
„ Perforated, three-hole punched, or torn
„ Too slick, too coarse, or too textured
„ Different in texture (roughness) on the front and back
„ Too thin or too thick
„ Stuck together with static electricity
„ Composed of foil or gilt; too luminous
„ Heat sensitive or cannot withstand the fusing temperature (180°C
[356°F])
„ Irregularly shaped (not rectangular or not cut at right angles)
„ Attached with glue, tape, paper clips, staples, ribbons, hooks, or buttons
„ Acidic
„ Any other media that is not approved
Thick Stock
Paper thicker than 90 g/m 2 (24 lb bond) is referred to as thick stock. Test all
thick stock to ensure acceptable performance and to ensure that the image
does not shift.
You can print continuously with thick stock. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, stop the continuous printing and print one sheet at a time.
DO NOT use thick stock that is
„
Mixed with any other media in the trays (as this will cause media misfeed-
ing)
Capacity Tray 1 Up to 50 sheets, depending on their thick-
ness
Orientation Face up
Driver
Media Type
Thick Stock 1
Thick Stock 2
Weight Thick Stock 1: 91 to 163 g/m 2 (25 to 43.5 lb bond)
Thick Stock 2: 164 to 209 g/m 2 (43.6 to 55.6 lb bond)