Konica Minolta bizhub C451 User Manual
Page 70
Using copy functions
2
C451
2-27
Using copy f
unct
ions
Chapter 2
4
Select the desired position.
– Touch [Auto] to automatically determine the
stapling or hole-punching position according to
the orientation of the loaded document. The
paper is stapled or holes are punched along the
long side of the paper if the document length is
11-11/16 inch (297 mm) or less or along the short
side of the paper if the document length is more
than 11-11/16 inch (297 mm).
When the “2 Position” Staple setting is selected
5
Touch [OK], and then touch [OK] in the next two
screens that appear. Otherwise, touch [Main
Screen].
The Basic screen appears again.
2
Note
The number of punched holes differs depending on the
country (region) where the unit is installed. For details,
consult your technical representative.