Network setup using a static ip address, Pre-requisites for using a static ip address, Connecting the machine using a static ip address – Xerox WorkCentre M118-M118i-15195 User Manual
Page 5
Network Setup Using a Static IP Address
Xerox WorkCentre M118/M118i
3
Network Setup Using a Static IP Address
When the machine is powered on, it automatically uses DHCP to obtain its network configuration. To use a
static IP address, DHCP must be turned off and the IP address, gateway address, subnet mask, and
DNS Server address must be entered manually.
Pre-Requisites for Using a Static IP Address
Before you begin, obtain the following information from your network administrator:
Connecting the Machine Using a Static IP Address
1.
Turn on the machine.
2.
When the machine is Ready, press the Log In/Out button.
3.
Press the Select button below the display to select
System Settings
.
a.
Use the numeric keypad to enter the
Password
. The default password is 11111.
b.
Press the Select button to select
Confirm
.
Turn DHCP Off
1.
Press the Select button to highlight
Print Settings
, and then press the Enter button.
2.
Press the the Enter button to select
Network/Port
.
3.
Press the Select button until you see
TCP/IP Settings
on the display, and then press the Enter button.
4.
Select
Get IP Address
, and then press the Enter button.
5.
Select
Manual
, and then press the Enter button.
6.
Press the Exit button.
IP Address:
__________ . __________ . __________ . __________
Gateway Address:
__________ . __________ . __________ . __________
Subnet Mask:
__________ . __________ . __________ . __________
DNS Server Address:
__________ . __________ . __________ . __________