Xerox WorkCentre M118-M118i-6209 - Manual (Page 4)

Verifying Network Setup Using CentreWare Internet Services (CentreWare IS)
Xerox WorkCentre M118/M118i
4
Set the Gateway Address
1. Press the Select button until you see Gateway Address on the display,, and then press the Enter button.
2. Use the numeric key pad to enter the first number of the gateway address, and then press the Right Arrow
button to move to the next field.
3. Repeat Step 2 to enter the remaining numbers.
4. Press the Enter button to accept the address.
5. Press the Exit button.
Set the Subnet Mask
1. Press the Select button until you see Subnet Mask on the display,, and then press the Enter button.
2. Use the numeric key pad to enter the first number of the subnet mask, and then press the Right Arrow
button to move to the next field.
3. Repeat Step 2 to enter the remaining numbers.
4. Press the Enter button to accept the subnet mask.
5. Press the Exit button.
6. Press the Log In/Out button to return to the main menu.
7. Use CentreWare IS to set the DNS server address. See Verifying Network Setup Using
CentreWare Internet Services (CentreWare IS) on page 4.
Verifying Network Setup Using CentreWare Internet
Services (CentreWare IS)
CentreWare IS provides a simple interface that enables you to manage, configure, and monitor networked
printers from your desktop using an embedded web server. CentreWare IS gives administrators easy access to
printer status, configuration, and diagnostic functions. It also provides users with access to printer status and
special printing functions such as printing saved jobs. With CentreWare IS software, you can access and
manage your printers over a TCP/IP network using a web browser.
Note
To enter network configuration settings via CentreWare IS, your computer must be on the same subnet as
the Xerox WorkCentre M118/M118i. For additional information about using CentreWare IS, see the
User Guide and the System Administration Guide.
To verify your network setup using CentreWare IS:
1. At your computer, launch your web browser.
2. Enter the machine’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx).
3. Click the Properties tab.
4. Select the Protocol Settings folder on the left sidebar, and then select TCP/IP.