AEG DE4003000B - Manual (Page 24)

2
1
2. Pull the rear end of the shelf sup-
port away from the side wall and re-
move it.
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
Valid with telescopic runners:
The retaining pins on the tele-
scopic shelf runners must point
to the front!
11.3 Oven lamp
WARNING!
There is a danger of electrical
shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or
switch off the circuit breaker.
Put a cloth on the bottom of the
oven for protection of the oven
light and glass cover.
Replacing the oven lamp
1. You can find the lamp glass cover at
the back of the cavity.
Turn the lamp glass cover counter-
clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with applica-
ble 300°C heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
11.4 Replacing the oven lamp
1. The oven lamp is on the left side of
the oven cavity. Remove the left
shelf rail for access to the lamp.
2. Use a narrow, blunt object (e.g. a
teaspoon) to remove the glass cov-
er. Clean the glass cover.
3. If necessary, replace the oven lamp
with an applicable 300 °C heat-re-
sistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
5. Install the left shelf rail.
24 www.aeg.com