AEG DE4003000M - Manual (Page 24)

11.1 Catalytic cavity cleaning
(selected models only)
WARNING!
You must not wipe out the cavity
side walls. It will damage the cat-
alytic surface.
To support this self-cleaning process
heat the oven without any food
regularly:
1. Open the oven door.
2. Remove all accessories from the
oven.
3. Wipe the floor of the oven clean with
warm washing-up solution and dry.
4. Close the door.
5. Set the oven CATA function. You will
find it in menu after other oven func-
tions.
6. Oven will switch off after one hour.
7. Clean the oven cavity with a soft and
damp sponge.
WARNING!
Before you wipe away wait until
the cavity is cool.
CAUTION!
Do not attempt to clean catalytic
surfaces with oven sprays, abra-
sive cleaners, soap or other
cleaning agents. This may dam-
age the catalytic surface.
Discolouration of the catalytic
surface has no effect on catalytic
properties.
11.2 Shelf supports
You can remove the shelf supports to
clean the side walls.
Removing the shelf supports
1. Pull the front of the shelf support
away from the side wall.
1
2
2. Pull the rear end of the shelf sup-
port away from the side wall and re-
move it.
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
Valid with telescopic runners:
The retaining pins on the tele-
scopic shelf runners must point
to the front!
24 www.aeg.com