Technology, Installation & connection – AEG Voltage Transformer ST 800 User Manual
Page 25
GB
25
1. Black connection (-)
2. red connection (+)
3. Mounting rail
4. earth connection
5. Fan cover
6. Isolated ground receptacle
7. power led, green
8. error led, red
9. power button
10. uSB connector
11. remote control module connector
12. Black cable with clamp (-)
13. red cable with clamp (+)
14. Black cable with lugs (-)
15. red cable with lugs (+)
16. remote control module
17. display
18. error led, red (remote control module)
19. power button (remote control module)
20. power led, green (remote control module)
TeCHnOlOgy
attention!
Check the properties of the device to be powered before using the voltage converter to prevent consequential damage.
There are pure or modified sinusoidal wave voltage converters.
Model
Item number
for connecting (examples)
Modified sinusoidal wave
▪
ST 500
▪
ST 800
▪
ST 1200
▪
97115
▪
97116
▪
97117
▪
power drills
▪
Computer
▪
Hobs
▪
lamps,
▪
Fans/vents
▪
lawn mowers
Pure sinusoidal wave
▪
Sw 600
▪
Sw 1000
▪
Sw 1500
▪
Sw 2000
▪
97120
▪
97121
▪
97122
▪
97123
in addition to the modified sinuso-
idal wave examples
▪
Coffee makers
▪
Shavers
▪
audio amplifiers
InSTallaTIOn & COnneCTIOn
Preparation
attention!
▪
Before connecting the power inverter you must check the connections on the vehicle‘s battery.
▪
If the „+” pole on the vehicle’s battery is connected to the chassis, you must not use the power converter with such
vehicles.
▪
Only use the included cables with lugs to connect to the 12 V direct current supply (e.g. automotive battery). If the
cables included are too short you may also use insulated copper cables available from speciality retailers.
▪
Keep the cable length as short as possible. The suitable cable diameter must be selected according to the length of
the cable between the inverter and the power source. when in doubt please contact a speciality retailer.