AEG BP7304021M - Manual (Page 31)

11. WHAT TO DO IF…
WARNING!
Refer to the Safety chapters.
Problem Possible cause Remedy
The appliance does not
heat up. The appliance is deacti-
vated. Activate the appliance.
The appliance does not
heat up. The clock is not set. Set the clock. Refer to
"Setting the time".
The appliance does not
heat up. The necessary settings
are not set. Make sure that the set-
tings are correct.
The appliance does not
heat up. The automatic cut-out is
activated. Refer to “Automatic
switch-off”.
The appliance does not
heat up. The fuse is released. Make sure that the fuse
is the cause of the mal-
function. If the fuse re-
leases again and again,
contact a qualified elec-
trician.
The lamp does not oper-
ate. The lamp is defective. Replace the lamp.
The display shows “C2”. You want to start the de-
frost function, but you
did not remove the core
temperature sensor plug
from the socket. Remove the core tem-
perature sensor plug
from the socket.
The display shows an er-
ror code that is not on
this list. There is an electrical
fault. • Deactivate the appli-
ance with the house
fuse or the safety
switch in the fuse box
and activate it again.
• If the display shows
the error code again,
contact the Customer
Care Department.
If you cannot find a solution to the prob-
lem yourself, contact your dealer or the
service centre.
The necessary data for the service centre
is on the rating plate. The rating plate is on the front frame of the appliance cavi-
ty.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
ENGLISH
31