4 steam generation system, 5 removing the oven door, 6 installing the oven door – AEG MCD3881E-M User Manual

Page 34: 7 replacing the lamp

Advertising
background image

12.4 Steam generation system

CAUTION!

Dry the steam generator

after each use. Remove the

water with the sponge.

Remove the limescale with

water and vinegar.

CAUTION!

Chemical de-scaling agents

can cause damage to the

enamel. Follow the

instructions of the

manufacturer.

1. To clean the water drawer and the

steam generator, put the water and

vinegar mixture (approximately 250

ml) through the water drawer into the

steam generator. Wait for

approximately 10 minutes.

2. Remove the water and vinegar with

the sponge.

3. Put clean water (100 - 200 ml) into the

water drawer to flush the steam

generation system.

4. Remove the water from the steam

generator with the sponge and rub it

dry.

5. Keep the door open to let the

appliance dry fully.

12.5 Removing the oven door

Remove the door to clean the inner side

of the appliance more easily.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully release the clamping levers on

the hinges.

3

4

2

3. Hold the door on the two sides and

close it approximately 3/4 of the way.

4. Pull the door away from the

appliance.

5. Put the door with the outer side

down on a soft cloth on a stable

surface. This is to prevent scratches.

12.6 Installing the oven door

WARNING!

Be careful when you install

the door. The door is heavy.

1. Hold the door on the two sides at an

angle of approximately 60°.

3

4

4

60º

5

2. At the same time push the door

hinges as far as they can go into the

two recesses at the bottom of the

appliance on the left and the right.

3. Lift the door up until you are at the

point of resistance and then open it

as far as possible.

4. Fully lock the clamping levers on the

hinges.

5. Close the door of the appliance.

12.7 Replacing the lamp

Put a cloth on the bottom of the interior

of the appliance. It prevents damage to

the lamp glass cover and the cavity.

WARNING!

Danger of electrocution!

Disconnect the fuse before

you replace the lamp.

The lamp and the lamp glass

cover can be hot.

1. Deactivate the appliance.

2. Remove the fuses from the fuse box

or deactivate the circuit breaker.

www.aeg.com

34

Advertising