AEG A72710GNW0 - Manual (Page 13)

9.3 Location
100 mm
15 mm 15 mm
The appliance should be installed well
away from sources of heat such as radia-
tors, boilers, direct sunlight etc. Ensure
that air can circulate freely around the
back of the cabinet.To ensure best per-
formance, if the appliance is positioned
below an overhanging wall unit, the mini-
mum distance between the top of the cab-
inet and the wall unit must be at least 100
mm . Ideally, however, the appliance
should not be positioned below overhang-
ing wall units. Accurate levelling is ensured
by one or more adjustable feet at the base
of the cabinet. If the cabinet is placed in a
corner and the side with the hinges facing
the wall, the distance between the wall
and the cabinet must be at least 10 mm to
allow the door to open enough so that the
shelves can be removed.
WARNING!
It must be possible to disconnect
the appliance from the mains pow-
er supply; the plug must therefore
be easily accessible after installa-
tion.
9.4 Door reversibility
To carry out the following opera-
tions, we suggest that this be
made with another person that
will keep a firm hold on the doors
of the appliance during the oper-
ations.
To change the opening direction of the
door, do these steps:
• Remove the plug from the power
socket.
• Tilt back the appliance carefully so
that the compressor cannot touch the
floor.
• Unscrew the left foot.
• Unscrew the screws of the door bot-
tom hinge.
ENGLISH
13