What to do if, 2 defrosting of the freezer, 3 no-frost technology – AEG A72710GNW0 User Manual

Page 9: 4 periods of non-operation

Advertising
background image

After cleaning, reconnect the equipment
to the mains supply.

6.2 Defrosting of the freezer

The freezer compartment of this model,
on the other hand, is a "no frost" type.
This means that there is no buildup of
frost when it is in operation, neither on
the internal walls nor on the foods.
The absence of frost is due to the con-
tinuous circulation of cold air inside the
compartment, driven by an automatically
controlled fan.

6.3 No-Frost technology

In order to facilitate the removal of the
ice layer, the evaporator is assisted by
electric heating during the defrosting
procedure. The ventilator is in OFF posi-
tion. The defrost water will drip in the
tray placed at the compressor and will
evaporate. In the course of the defrost-
ing procedure (approx. 30 minutes) the
evaporator becomes warm but it has no
influence on the internal temperature.

The foods should be kept well-packed in
order to avoid any moisture loss as a re-
sult of air circulation.
Do not obstruct the vent holes.
It is recommended to put all foods in the
baskets in the freezer compartment.

6.4 Periods of non-operation

When the appliance is not in use for
long periods, take the following precau-
tions:

1.

disconnect the appliance from elec-
tricity supply

2.

remove all food

3.

clean the appliance and all accesso-
ries

4.

leave the lid open to prevent un-
pleasant smells.

If the cabinet will be kept on, ask
somebody to check it once in a
while to prevent the food inside
from spoiling in case of a power
failure.

7. WHAT TO DO IF…

WARNING!
Before troubleshooting, discon-
nect the mains plug from the
mains socket.
Only a qualified electrician or
competent person must do the
troubleshooting that is not in this
manual.

There are some sounds during
normal use (compressor, refriger-
ant circulation).

The appliance operates discon-
tinuously, so the stopping of
compressor does not mean be-
ing no current. That is why you
must not touch the electrical
parts of the appliance before
breaking the circuit.

Problem

Possible cause

Solution

The appliance is
noisy

The appliance is not sup-
ported properly

Check if the appliance
stands stable (all the four
feet should be on the
floor)

The compressor op-
erates continually

The thermostatic control
is set incorrectly

Set a warmer temperature

Doors are not shut prop-
erly or do not close tightly

Check if the doors close
well and the gaskets are
undamaged and clean

ENGLISH

9

Advertising