AEG A72710GNW0 - Manual (Page 14)

2
1
• Take off the appliance door by pulling
it slightly downwards.
• Unscrew the top door hinge pin of the
appliance then screw it back on the
other side.
• Fit the appliance door on the upper
door hinge pin.
• Remove the lower hinge. Put over the
pin in the direction of the arrow.
• Unscrew and install the screw on the
opposite side.
• Install the lower hinge on the opposite
side leaving the position of the door
unchanged.
• Screw in the one screw in the place set
free on the other side as well as the
right adjustable foot .
1
2
3
4
• Remove and install the handle (if fore-
seen) on the opposite side.
• Reposition, level the appliance, wait
for at least four hours and then con-
nect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly
to the cabinet. In that case, wait for the
natural fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact
the nearest After Sales Service Force.
The After Sales Service specialist will car-
ry out the reversibility of the doors at
your cost.
9.5 Electrical Connection
CAUTION!
Any electrical work required to
install this appliance should be
carried out by a qualified electri-
cian or competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any li-
ability should these safety meas-
ures not be observed.
14 www.aeg.com