4 steam generation system, 5 removing and installing the oven door – AEG BS8314001M User Manual

Page 43

Advertising
background image

The display shows the duration of the

function. An acoustic signal sounds when

the programme is completed.

3. Touch a sensor field to deactivate

the signal.

4. Wipe out the appliance with a soft

cloth. Remove the water from the

steam generator.

Keep the appliance door open for

approximately 1 hour. Wait until the

appliance is dry. To speed up the drying

you can heat up the appliance with hot

air at temperature 150 °C for

approximately 15 minutes.

12.4 Steam generation system

CAUTION!

Dry the steam generator after

each use. Remove the water

with the sponge.

Remove the limescale with

water and vinegar.

CAUTION!

Chemical de-scaling agents

can cause damage to the

enamel. Follow the

instructions of the

manufacturer.

1. To clean the water drawer and the

steam generator, put the water and

vinegar mixture (approximately 250

ml) through the water drawer into the

steam generator. Wait for

approximately 10 minutes.

2. Remove the water and vinegar with

the sponge.

3. Put clean water (100 - 200 ml) into the

water drawer to flush the steam

generation system.

4. Remove the water from the steam

generator with the sponge and rub it

dry.

5. Keep the door open to let the

appliance dry fully.

12.5 Removing and installing

the oven door

You can remove the oven door and the

internal glass panels to clean it. The

number of glass panels is different for

different models.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A) on

the two door hinges.

A

A

3. Close the oven door to the first

opening position (approximately 70°

angle).

4. Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

5. Put the door with the outer side

down on a soft cloth on a stable

surface. This is to prevent scratches.

6. Hold the door trim (B) on the top

edge of the door at the two sides

and push inwards to release the clip

seal.

1

2

B

7. Pull the door trim to the front to

remove it.

8. Hold the door glass panels on their

top edge one by one and pull them

up out of the guide.

ENGLISH

43

Advertising