A&D WM:PD4000136 Ambulatory Blood Pressure Monitor - Manual (Page 21)

Page 19
Deleting Old Data
Caution ❏ When the data is to be deleted, confirm that the data has
already been transferred and saved. It is not possible to
recover data that has been deleted.
❏ It is not possible to completely delete data, if the START STOP
key is released while the beeper sounds at Step 2.
Steps for deleting old data
Step 1 Press and hold the START STOP key until is displayed. If you want
to cancel this process, press the AUTO ON/OFF key.
Step 2 Press and hold the START STOP key once more until the beeper becomes silent.
Resetting the Recorder
If the recorder does not work correctly, press the reset key. The recorder
deletes all data and parameters. The internal system is initialized.
Caution ❏ All data and parameters are deleted and preset initial pa-
rameters are reset.
❏ Do not press the reset switch too hard. Press this key gently so
as not to damage the components inside.
❏ Keep foreign matter away from the reset switch hole.
Steps for reset
ON
OFF
SYS/INTER
VAL
DIA PULSE/TIME
A I R
AUT
O ON/OFF
STAR
T STOP
0
1
2
0 1 2 3 4 5 6 7 8 9
Reset key
Step 1 Open the battery cover.
Step 2 Turn off the power switch.
Step 3 Remove the batteries from the recorder.
Step 4 Press the reset key gently.
Step 5 Place new batteries in the recorder.
Step 6 Turn on the power switch. The recorder sounds the
buzzer four times and E00 is displayed blinking.
Step 7 Set the parameters for the display and clock. Also,
adjust the parameters for automatic measurement.
Initializing the recorder Deleting Old Data