AT&T TL96371 - Manual (Page 10)

6
Battery installation and charging
Install the battery as shown on page 7. Once you have installed
the battery, the screen indicates the battery status (see the table
below). If necessary, place the handset in the telephone base or
charger to charge the battery. For best performance, keep the
handset in the telephone base or charger when not in use. The
battery is fully charged after 16 hours of continuous charging.
See the table on page 31 for battery operating times.
If the screen shows
Place in charger and flashes, you need to
charge the handset without interruption fo r at least 30 minutes
to give the handset enough charge to use the telephone for a
short time.
The following table summarizes the battery charge
indicators and actions to take.
�attery indicators �attery status Action
The screen is blank
or shows
Place
in charger and
flashes.
The battery has no or
very little charge. The
handset cannot be used. Charge without interruption
(at least 30 minutes).
The screen shows
Low battery and
flashes. Battery has enough
charge to be used for a
short time. Charge without interruption
(at least 30 minutes).
The screen shows
�ANDSET X. Battery is charged. To keep the battery
charged, place it in the
telephone base or charger
when not in use.
NOTE: If you are on a phone call in low battery mode, you hear four short
beeps every minute.
Getting started