AEG AR 4020 - Manual (Page 67)

67 ENGLISH
Remove sleeve (D) and frame (B) from the unit. Use ‹
installation keys (C), if necessary.
Place the sleeve in the ISO slot. ‹
Bend the claws outward with a screwdriver for perfect ‹
fit.
Check the sleeve for tight fit. ‹
Connect the ISO female connectors of the unit with ‹
the two ISO male connectors of the vehicle.
Connect the antenna to the antenna connector at the ‹
rear of the unit.
Secure the unit against theft, if necessary. Attach bolt ‹
and mounting strip with the fastening materials at the
firewall.
Carefully slide the unit into the sleeve until it locks ‹
into place.
Press ‹ RESET (25) with a pen or other pointed object
after all connections are made.
Attach the front panel (A) as described under “Attach ‹
Front Panel”.
CAUTION
Cable damage possible!
To avoid cable damage observe the cables when slid- ►
ing the unit into the sleeve.
Attach the frame. ‹
Remove Unit
Follow these instructions to remove the unit: ‹
Remove the frame. ‹
Insert left and right installation keys in the slots left ‹
and right (the claws are now bent back).
Slide the unit out of the sleeve. ‹
NOTE
Unevenness of the casing can cause the claws to ►
lock. Unlock the claws with the installation keys, if
necessary.
Toyota or Nissan Installation
NOTE
Sleeve, frame and mounting strip are not needed. ►
Use the threads on the side of the casing (A) to mount the
unit on the vehicle bracket (supplied with your car). The
holes are marked with T (for Toyota) and N (for Nissan).
A
B
C
D
B
Loosen the mounting screws for the hooks left and ‹
right at the front of the unit and remove the hooks.
Mount the brackets (B) with screws on the unit (D). ‹
Connect External Audio Device
Connect line out of the external audio device to ‹ AUX
IN (12) jack on the front panel.
Select playback mode for external device by repeatedly ‹
pressing MODE (22) until AUX is displayed.