AEG AR 4020 - Manual (Page 68)

68 ENGLISH
Start-up
To protect against theft remove the front panel. Do not
keep the front panel in the car.
NOTE
Keep the front panel in its casing. ►
Do not touch the contacts on the unit or on the ►
front panel.
Attach Front Panel
Set the control panel with the left-hand side first into ‹
the frame.
Then push the right-hand side in until it clicks into ‹
place.
Flip the control panel up until it clicks into place. ‹
Ensure the front panel is attached properly. If the front ‹
panel is not attached properly this can cause malfunc-
tions.
Detach Front Panel
Press the release button (1) and flip the control panel ‹
down.
Then pull gently on the right-hand side of the control ‹
panel to detach the control panel.
Operation
This chapter gives important operating instructions for
the unit.
On/Off
Press the button ‹ /MUTE (11) to switch on the set. The
display is activated.
Hold down the ‹ /MUTE (11) button to switch the unit
off.
Settings
Volume
WARNING
Hearing damage due to high volume!
High volumes can permanently damage your hearing.
Set a moderate volume. ►
Turn the multi control knob (21) to set the volume. ‹
Switch unit to mute
Press the ‹ /MUTE (11) button to switch the unit to
mute. The MUTE indicator appears on the display.
Press the ‹ /MUTE (11) button again to deactivate the
function.
Sound Settings
Press the multi control knob (21).The current volume is ‹
displayed. Press again to cycle through the next setting
options.
The following settings are possible:
VOL - volume (0 to 100)
BAS - bass (-10 to +10)
TRB - treble (-10 to +10)
BAL - Balance (sound distribution between left and
right speakers) (10L to 10R)
FAD - Fader (sound distribution between rear and front
speakers) (10F to 10R)
Turn the multi control knob to change the displayed ‹
setting.