Brother Laser Printer HL1660e - Manual (Page 275)

2001/10/02
CHAPTER 6 EPSON - 12
User reset
EscCR!#R (27)(13)(33)#(82) <1Bh><0Dh><21h>#<52h>
•
# = 0, the printer restores to the current user setting.
•
# = 1, the printer restores to user settings 1.
•
# = 2, the printer restores to user settings 2.
Paper Input Control
EscEMn (27)(25)n <1Bh><19h>n
n Value HL-1660e/2060/2400C/2400Ce/3400CN/3260N/2460
n = 0 Initialize the feeder mode.
n = 1 Feed from the MP tray.
n = 2 Feed from Tray 1.
n = 3 Feed from Tray 2.
n = 4 Feed from Tray 3.
n = 5 Feed from Tray 4.
n = R Eject paper.
n Value HL-1050
n = 0 Initialize the feeder mode.
n = 1/2 Feed from the tray.
n = R Eject paper.
n Value HL-1250/1270N/1450/1470N/P2500/1650/1670N
n = 0 Initialize the feeder mode.
n = 1 Feed from the Tray 1.
n = 2 Feed from the Tray 2.
n = R Eject paper.
Enable out-of-paper sensor
Esc9 (27)(57) <1Bh><39h>
The printer ignores this command.
Disable out-of-paper sensor
Esc8 (27)(56) <1Bh><38h>
The printer ignores this command.
6.2. Page set up
Set page length
EscCn (27)(67)n <1Bh><43h>n
This command sets the page length in lines.
or
EscCNULn (27)(67)(00)n <1Bh><43h><00h>n
•
This command sets the page length in inches.
•
The top of form position is set to be the current line.
•
n is the number of lines that make up one page, or the length of the page in inches, according to which
form of the command is used.
•
If the first form of the command is used (n = the number of lines in the page) the current line spacing
setting is used to determine the length of the page.
•
If the first form of the command is used, n must be in the range 1 to 127.