AEG BSS 4808 - Manual (Page 52)

English
52
6. For repeated playback of the programmes, press the
PLAY/PAUSE button.
7. To delete memory, please press STOP button twice.
MEMORY will no longer be displayed.
The device will stop automatically after all stored tracks have
been played. The program sequence will be kept in the
memory until you switch to another mode, remove the CD
from the compartment or switch off the device.
It is possible to combine program playback with the REPEAT
function. After programming and starting playback, please
press REPEAT button (6/13) up to three times; the functions
can be applied as described under “REPEAT“.
Playback of music files in MP3 format
This device allows the playback of music files in MP3 format.
The device furthermore supports the common CD types: CD,
CD-RW, and CD-R.
Your device can play MP3 CDs. These are compressed CDs
that can store up to 200 tracks. Your device automatically
recognizes MP3 discs (the display will show total number of
tracks and folders). Please refer to chapter “Playing CD/MP3”
for playback of such CDs. You may program tracks as already
described under “Program playback”.
Please note:
There are many burning and compressing methods, as well
as differences in quality of CDs and burnt CDs.
Furthermore, the music industry does not apply fixed stan-
dards (copy protection).
For that reason there might, in rare cases, occur problems
when playing CDs and MP3 discs. That is
not a malfunction
of this device.
Cleaning and maintenance
• Disconnect the mains plug before cleaning.
• You may wipe off external stains, using a slightly damp
cloth without any additives.
Troubleshooting
Symptoms Course Solution
CD can not be
played back. CD is not inserted or
inserted incorrectly. Ensure that the disc
is inserted with the
label facing upwards.
Batteries too weak. Insert new batteries
or operate the device
with the mains lead.
CD jumps dur-
ing playback. Check the disc for
fingerprints, dirt or
scratches. Check the disc for
fingerprints, dirt or
scratches.
The unit does
not work. The unit is blocked
and “hangs”. Disconnect the mains
plug for approxi-
mately 5 seconds.
Then switch the unit
back on.
Volume (3)
and basses
(20) cannot be
adjusted on
the device. The PROG but-
ton (10/4) was held
pressed down until
the time display ap-
peared. Then one
of the controls was
pressed while the
time was displayed. Press any button to
release the lock of
the control.
No audio
signal via the
Bluetooth
connection Speaker is not paired
to the audio source. Check whether a
connection exists. If
necessary, pair the
speaker again to the
audio source.
Volume too low Increase the volume
on the speaker
Increase the volume
on the audio source.
Speaker
cannot be
connected Pairing does not work Check whether
the audio source
supports the A2DP
protocol.
Audio source is
switched off Switch on the audio
source
Bluetooth is switched
off at the audio
source. Switch on the
Bluetooth function in
the audio source.
Bluetooth version is
not supported. Use a different
playback unit.