Belkin Pre-N - Manual (Page 14)

13 12
Setting Up your Computers
13 12
Setting Up your Computers
Manually Configuring Network Adapters in Windows 98SE or Me
1.
Right-click on “My Network Neighborhood” and select “Properties” from
the drop-down menu.
2.
Select “TCP/IP -> settings” for your installed network adapter. You will
see the following window.
3.
If “Specify an IP address” is selected, your Router will need to be set up
for a static IP connection type. Write the address information in the table
below. You will need to enter this information into the Router.
(1)
(2)
(3)
4.
Write the IP address and subnet mask from the “IP Address” tab (3).
5. Click the “Gateway” tab (2). Write the gateway address down in the chart.
6.
Click the “DNS Configuration” tab (1). Write the DNS address(es) in the chart.
7.
If not already selected, select “Obtain an IP address automatically” on the
IP address tab. Click “OK”.
8.
You will also need to delete the Gateway address from the Gateway tab
and DNS Configuration entries in order to properly be configured for
connection to the Belkin router.
Restart the computer. When the computer restarts, your network
adapter(s) are now configured for use with the Router.