Belkin Pre-N - Manual (Page 54)

53 52
Manually Configuring your Router
53 52
Manually Configuring your Router
1
Wireless channels must match between Router and AP.
2
Security settings (WEP) must match between Router and AP.
3
If MAC filtering is enabled, user must be sure to add the WLAN MAC
address(es) of the Router/AP in order to allow communication with each
other.
4
If using a network protected by WPA, the SSID on both Access Points
must be the same.
Firewall
Your Router is equipped with a firewall that will protect your network
from a wide array of common hacker attacks including:
• IP Spoofing
• Land Attack
• Ping of Death (PoD)
• Denial of Service (DoS)
• IP with zero length
• Smurf Attack
• TCP Null Scan • SYN flood
• UDP flooding
• Tear Drop Attack
• ICMP defect
• RIP defect
• Fragment flooding
The firewall also masks common ports that are frequently used to
attack networks. These ports appear to be “Stealth”, meaning that
essentially they do not exist to a would-be hacker. You can turn the
firewall function off if needed; however, it is recommended that you
leave the firewall enabled. Disabling the firewall protection will not
leave your network completely vulnerable to hacker attacks, but it is
recommended that you leave the firewall enabled.