AEG MC2664E-M - Manual (Page 8)

8 www.aeg.com 8 www.aeg.com
Turntable installation
1. Place the turntable support on the
cavity bottom.
2. Place the turntable on top of the
turntable support as shown in the
diagram. Make sure that turntable
hub is securely locked in the
turntable shaft. never place the
turntable upside down.
• Both turntable and turntable support
must always be used
• All food and containers of food are
always placed on this turntable for
cooking.
• This turntable rotates clockwise and
anticlockwise; this is normal.
Setting the clock
after your microwave oven is first
plugged-in or after a power failure, the
clock display will flash to indicate that the
time shown is not correct. Before using
the microwave oven, adjust the clock
through the procedure described below
but starting on Step 2.
to set the clock, proceed as follows:
1. Press the “Clock” key until the hours
start to flash.
2. turn the rotary encoder to set the
required hours.
3. Press the “Clock” key until the
minutes start to flash.
4. turn the rotary encoder to set the
required minutes.
5. to finish, press the clock key again.
Child lock
the oven functioning can be blocked
(for example to stop it being used by
children).
1. to block the oven, press the “auto
Cook” and “Clock” key for 2
seconds. a lock will appear in the
display.
2. to unblock the oven repeat the
operation.
Interrupting a cooking cycle
you can stop the cooking process at any
time by pressing the Stop key once or by
opening the oven door. in both cases:
• Microwave emission is stopped
immediately.
• The grill is de-activated but is still very
hot. danger of burning!
• The timer stops automatically,
indicating the operating time that is
left.
if you wish, at this time you can:
turn or stir the food to ensure it will
evenly be cooked.
to restart the process, close the door
and press the Start key.
Kitchen timer
this function can be used as a minute
minder. When using this function you are
not defining how long you wish the timer
to run but you are defining at which time
you wish the alarm to sound.
1. Press the “Clock” key until the hours
start to flash.
2. turn the rotary encoder to set the
required hours.
3. Press the “Clock” key until the
minutes start to flash.
4. turn the rotary encoder to set the
required minutes.
5. Press the “Start” key.
4. BEFORE FIRST USE