Olympus DM-2 - Manual (Page 25)


1
EN
Po
w
er s
up
ply
Connect to the USB connecting AC
adapter (optional) to charge
It can be charged by connecting to the USB
connecting AC adapter (A514) (optional).
Before connecting the AC adapter, switch
the USB Connection setting to [AC] (☞ P.96).
1 Plug the AC adapter into AC
outlet.
2 Plug the recorder’s USB
connecting cable into the AC
adapter.
3 Make sure that the recorder is
turned off, connect the USB cable
to the connecting terminal on the
bottom of this recorder.
• Charging has started when LED
indicator light is orange and the battery
indicator on the display changes to the
charging indicator.
Notes
• The recorder cannot be charged when the
PC is not turned on. Also, it may not be
charged when the PC is not switched on,
or when it is in the standby, hibernate or
sleep mode.
• Do not charge the recorder with the USB
hub connected.
• Charging is completed when battery
indication becomes [<] (charging time:
approximately 3 hours *).
* It shows the approximate time when
charging the rechargeable battery fully
from no remaining power at the room
temperature. The charging time will be
changed depending on the remaining
amount and the state of battery.
• You cannot charge when [;]*1 or [=]*2
is displayed. Charge the battery at the
temperature from 5°C to 35°C (41°F to 95°F).
*1 [;]: When surrounding temperature is
low.
*2 [=]: When surrounding temperature is
high.
• When using time becomes notably short
even after the battery are fully charged,
replace them with new ones.
• Be sure to push the USB connector all the
way in. Otherwise, the recorder may not
operate properly.
• Be sure to use the attached dedicated
cable for the USB connection cable. If
any other company’s cable is used, it
may cause problems. Also, please do not
connect this dedicated cable to any other
company’s product.
Power supply