Olympus PT-038 - Manual (Page 56)

EN 18
EN
Load the digital camera.
1 Confirm that the digital camera is OFF.
2 Set the mode dial of the digital camera to “SCENE” and gently insert the
digital camera into the Case.
CAUTION:
If the digital camera is not inserted properly, it may not be possible to seal the
case so that it is airtight. Alternatively, some controls may become inoperable.
Note that imperfect sealing may result in water leakage.
Insertion of silica gel
Before sealing the Case, insert the
silica gel bag provided for
prevention of fogging between the
bottom of the camera and the Case.
CAUTION:
• Insert the silica gel all the way at the specified location and with the
specified orientation. When the orientation is not correct, the silica gel bag
will be caught when the Case is sealed and water leakage will occur.
• If the Case is sealed without inserting the silica gel fully, the silica gel bag will
be caught by the O-ring and water leakage will occur.
• Once silica gel has been used, the moisture absorption performance will be
impaired. Always replace the silica gel when the Case is opened and closed.
Pay attention to the orientation.
PT038_EN.book Page 18 Tuesday, December 26, 2006 12:54 PM