Olympus SP-700 - Manual (Page 154)

Troubleshooting
154
9
Appendix
Pictures you have taken do not appear on the monitor.
The power is off.
Move the mode switch to the q position and
then press the o button.
P. 11
The camera is in the
shooting mode. Press the QUICK VIEW button or set the
mode switch to
q and switch to playback
mode.
P. 9
There are no pictures in
the internal memory or
on the card. [NO PICTURE] is displayed on the monitor.
Record pictures. –
There is a problem with
the card. See “Error messages”. P. 147
The camera is
connected to a TV. The monitor does not function when the AV
cable is connected to the camera. P. 89
Single-frame erase, erase selected and all-frame erase cannot be performed.
The pictures are
protected.
Cancel the protection of the pictures. P. 91
No picture is displayed on the TV when connected to the camera.
The video output signal
is incorrect.
Set the video output signal according to the
region where used. P. 90
The TV video signal
setting is incorrect. Set the TV to the video input mode. –
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
Use [s] to adjust monitor brightness. P. 107
The monitor is exposed
to direct sunlight. Block the sunlight with your hand. –
FRAME/LABLE do not work
There are no frame or
titles for combining in the
camera
Use OLYMPUS Master to erase unneeded
frames or labels. For details, refer to the
OLYMPUS Master software help or manual. –
Possible cause Corrective action
Ref.
page