Olympus SP-700 - Manual (Page 155)

Troubleshooting
155
9
Appendix
(When the camera is connected to a computer or printer
Possible cause Corrective action
Ref.
page
The printer fails to connect.
[PC] was selected on the
monitor after connecting
the camera to the printer
with the USB cable.
Remove the USB cable, and start again from
Step 1 of “Printing pictures”. P. 116,
118
The printer does not
support PictBridge. Refer to the instruction manual for your
printer. Or, contact your printer manufacturer. –
The camera is not recognized by the computer.
The computer failed to
recognize the camera.
Disconnect the USB cable from the camera,
and connect it again. P. 137
The USB driver has not
been installed. Install OLYMPUS Master. P. 133