Olympus E-30 - Manual (Page 97)

97
EN
7
Cust
omizing your
c
amer
a
MY MODE SETUP
You can store two frequently used settings as My Mode. You can select which My Mode
setting to use in advance by following the steps under “Executing” below. To use My Mode,
set [
; FUNCTION] to [MY MODE] and hold down the < button while shooting. g“;
FUNCTION” (P. 96)
Registering
1) Select [MY MODE1] or [MY MODE2] and press
d.
2) Select [SET] and press the i button.
• The current settings are registered in the camera. For details on the functions that can
be registered to My Mode, refer to “Functions that can be registered with My Mode and
Custom Reset Setting” (
gP. 136).
• To cancel the registration, select [RESET].
Executing
1) Select [MY MODE1] or [MY MODE2] and press the
i button.
2) Select [YES] and press the i button.
• The selected My Mode is set.
• When shooting, press the shutter button while holding down the
< button.
BUTTON TIMER
The direct button may remain selected even after it is released.
[OFF] Available only when the button is pressed.
[3SEC]/[5SEC]/[8SEC] The button remains selected during the number of seconds
indicated.
[HOLD] The button remains selected until you press it again.
• Buttons that can be set with [BUTTON TIMER]
ISO, F, WB, #, w, G, AF, </Y/j
A
You can switch the functions of the AEL/AFL button and the < button. When you select
[ON], the AEL/AFL button will function as the < button, and the < button will function as
the AEL/AFL button.
• The setting also applies to the < button on the optional power battery holder when
attached to the camera.
n FUNCTION
When selecting P, you can use the arrow pad to select the position of the AF target. You
can perform this operation for several seconds after pressing the shutter button halfway and
then releasing it.
g“Selecting the AF target position” (P. 56)
Custom Menu 1 c RELEASE/j
RLS PRIORITY S/RLS PRIORITY C
Normally, this camera does not release the shutter while the AF is operating or the flash is
charging. If you want to release the shutter without waiting until these operations have
completed, use the setting below. You can set the release priority individually in AF mode.
RLS PRIORITY S
Sets release priority for S-AF mode gP. 53.
RLS PRIORITY C Sets release priority for C-AF mode gP. 54.
s0017_e_00_0_unified.book Page 97 Thursday, October 30, 2008 2:47 PM