Olympus Stylus 800 Digital - Manual (Page 131)

Troubleshooting
131
9
Appendix
The monitor is hard to see.
There is condensation
*
inside the camera.
Turn the camera off. Before turning it on
again, wait until the camera adjusts to the
surrounding temperature and dries out. –
The brightness of the
monitor is not adjusted
properly. Use [s] to adjust the brightness. P. 91
The monitor is exposed
to direct sunlight. Block the sunlight with your hand. –
Vertical lines appear on
the monitor screen
during shooting. Aiming the camera at a bright subject in
sunlight may cause vertical lines to appear
on the screen. This is not a malfunction. –
The date recorded with the image data is wrong.
The date and time is not
set.
Set the date and time. The clock is not preset. P. 92
The camera has been
left without the battery. If the camera is left for 1 day without a
battery, the date and time setting is canceled.
Set the date and time again. P. 92
The settings are returned to the factory default settings when the camera is turned
off.
[ALL RESET] is set to
[ON].
Set [ALL RESET] to [OFF]. P. 85
The picture is out of focus.
The subject was too
close.
Move further away from the subject. To take
pictures at 20 to 50 cm (7.9 in. to 19.7 in.)
from your subject, use macro mode. To take
pictures closer than 20 cm (7.9 in.), use super
macro mode. P. 40
Auto focus is not
possible. Use the focus lock to focus on the subject. P. 22
There is condensation *
inside the camera.
Turn the camera off. Before turning it on
again, wait until the camera adjusts to the
surrounding temperature and dries out. –
The monitor goes off.
The camera is in the
sleep mode.
Press the shutter button or zoom button. –
Possible cause Corrective action
Ref.
page