Olympus µ-7000 - Manual (Page 55)

55 EN
Appendix
Battery and charger
This camera uses one Olympus lithium-ion
battery (LI-42B/LI-40B). No other type of
batteries can be used.
CAUTION:
There is a risk of explosion if the battery
is replaced with the incorrect battery type.
Dispose of the used battery following the
instructions. “Battery Handling Precautions”
(p. 61)
Power consumption by the camera varies
depending on which functions are used.
During the conditions described below, power is
consumed continuously and the battery becomes
exhausted quickly.
The zoom is used repeatedly.
The shutter button is pressed halfway
repeatedly in shooting mode, activating the
auto focus.
A picture is displayed on the monitor for an
extended period of time.
The camera is connected to a computer or
printer.
Using an exhausted battery may cause the
camera to turn off without displaying the battery
level warning.
The rechargeable battery is not fully charged at
the time of purchase. Charge the battery fully
with LI-41C/LI-40C charger before use.
The provided rechargeable battery usually takes
approximately 2 hours to charge (varies with
usage).
The supplied LI-41C battery charger is used only
for LI-42B/LI-40B battery. Do not charge other
type of battery with the supplied battery charger.
It might cause explosion, leaking, overheating
or fire.
For plug-in type battery charger:
This power unit is intended to be correctly
orientated in a vertical or floor mount position.
•
•
•
•
•
•
•
•
•
•
•
•
Camera care
Exterior
Wipe gently with a soft cloth. If the camera is
very dirty, soak the cloth in mild soapy water and
wring well. Wipe the camera with the damp cloth
and then dry it with a dry cloth. If you have used
the camera at the beach, use a cloth soaked in
clean water and wrung well.
Monitor
Wipe gently with a soft cloth.
Lens
Blow dust off the lens with a commercial blower,
then wipe gently with a lens cleaner.
Battery/Charger
Wipe gently with a soft, dry cloth.
Do not use strong solvents, such as benzene
or alcohol, or chemically treated cloth.
Mold may form on the lens surface if the lens is
left dirty.
Storage
When storing the camera for extended periods,
remove the battery, AC adapter and card, and
keep in a cool, dry place that is well ventilated.
Periodically insert the battery and test the
camera functions.
Avoid leaving the camera in places where
chemical products are handled since this may
result in corrosion.
•
•
•
•
•
•