Olympus E-520 - Manual (Page 75)

Flash s
h
ooting
7
75
EN
4
Use the super control panel to set the flash mode and other settings for each group.
5
Select a flash mode.
• Red-eye reduction flash is not possible in RC mode.
6
Press the # button to raise the built-in flash.
7
After shooting preparations are completed, take some test shots to check the flash
operation and images.
8
Begin shooting while checking the charging completed indications of the camera
and flash.
x
Notes
• Although there is no limit to the number of wireless flashes you can use, it is recommended that
each group have no more than three flashes to prevent flash malfunction due to mutual
interference.
• In RC mode, the built-in flash is used to control the wireless flash. The built-in flash cannot be used
for flash shooting in this mode.
• For 2nd curtain synchronization, set the shutter speed and anti-shock settings to within 4 seconds.
Wireless flash shooting may not operate properly when using a slower shutter speed or anti-shock
setting.
2
LO M
TTL
1 / 8
–
+1.0
OFF
2008. 08.16
RC
Flash control mode
Group
• Select the flash
control mode and
adjust the flash
intensity individually
for groups A, B, and
C. For MANUAL,
select the flash
intensity.
Flash intensity value
Communication light level
• Set the communication light level to
[HI], [MID], or [LO].
Channel
• Set the communication channel to
the same channel used on the
flash.
Normal flash / Super FP flash
• Switch between normal flash and
Super FP flash.
Flash intensity