Olympus µ-mini DIGITAL S User Manual
Page 131
Troubleshooting
10
Ap
pen
d
ix
131
(When the camera is connected to a computer or printer
Pictures you have taken do not appear on the monitor.
The power is off.
Set the mode dial to
q, then press the
POWER switch to turn the camera on.
The camera is in the
shooting mode.
Press the QUICK VIEW button or set the
mode dial to
q.
There are no pictures on
the card.
[NO PICTURE] is displayed on the monitor.
Record pictures.
–
There is a problem with
the card.
See “Error codes”.
The camera is
connected to a TV.
The monitor does not function when the AV
cable is connected to the camera.
Single-frame erase and all-frame erase cannot be performed.
The pictures are
protected.
Display pictures with
9 and set [0] from
[MODE MENU] to [OFF] to cancel protection.
No picture is displayed on the TV when connected to the camera.
The video output signal
is incorrect.
Set the video output signal according to the
region where used.
The TV video signal
setting is incorrect.
Set the TV to the video input mode.
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
Select [s] in the mode menu and adjust the
brightness.
The monitor is exposed
to direct sunlight.
Block the sunlight with your hand.
–
Possible cause
Corrective action
Ref.
page
The printer fails to connect.
[PC] was selected on the
monitor after connecting
the camera to the printer
with the USB cable.
Remove the USB cable, and start again from
Step 1 of “Connecting the camera to a
printer”.
The printer does not
support PictBridge.
Refer to the printer’s instruction manual or
contact the manufacturer.
–
The camera is not recognized by the computer.
The USB driver has not
been installed.
Install OLYMPUS Master.
–
Possible cause
Corrective action
Ref.
page