Olympus µ 1000 - Manual (Page 55)

EN
55
Get
ti
ng
to
kn
ow yo
ur c
amera
bet
te
r
This camera uses several lamps to indicate the camera status.
• Performing any of the following operations when not actually taking pictures can deplete
the battery power.
• Repeatedly pressing the shutter button halfway
• Repeatedly using the zoom
• To minimize the battery consumption, turn off the camera whenever it is not in use.
• Some items may not be selectable from the menus when using the arrow pad.
• Items that cannot be set with the current shooting mode
• Items that cannot be set because of an item that has already been set:
[ %], “flash”, etc.
• Items that cannot be set because the pictures taken by other camera will be edited.
• Some functions cannot be used when there is no card in the camera.
[PANORAMA], [PRINT ORDER], [ALBUM] [ALBUM ENTRY], [UNDO ENTRY],
[LABEL IMAGE], [FORMAT], [BACKUP]
Lamp indicators
Lamp Status
Self-timer lamp The lamp lights for approximately 10 seconds, blinks for
approximately 2 seconds, and then the picture is taken.
Card access lamp Blinking: An image or movie is being recorder or
downloaded (when connected to a computer).
• Do not do any of the following while the card access lamp is
blinking. Doing so may prevent the image data from being
saved and render the internal memory or card unusable.
• Open the battery compartment/card cover
• Remove the battery.
• Connect or disconnect the AC adapter.
Green lamp of the
monitor Lit: The focus and exposure are locked.
Blinking: The focus and exposure are not locked.
• Release your finger from the shutter button, re-position
the AF target mark on the subject and press the shutter
button halfway again.
Extending the useful life of the battery
Functions that cannot be selected from menus