When you get an error message on the camera – Olympus µ 1000 User Manual
Page 59
EN
59
Get
ti
ng
to
kn
ow yo
ur c
amera
bet
te
r
When you get an error message on the camera...
Monitor indication
Possible cause
Corrective action
q
CARD ERROR
There is a problem with the
card.
This card cannot be used. Insert a new
card.
q
WRITE-PROTECT
Writing to the card is
prohibited.
The recorded image has been protected
(read-only) on a computer. Download the
image to a computer and cancel the read-
only setting.
>
MEMORY FULL
The internal memory has no
available memory and
cannot store any new data.
Insert a card or erase unwanted data.
Before erasing, back up the data of
important pictures onto the card, or
download such pictures to a computer.
q
CARD FULL
The card has no available
memory and cannot store
any new data.
Replace the card or erase unwanted data.
Before erasing, download important pictures
to a computer.
L
NO PICTURE
There are no pictures in the
internal memory or on the
card.
The internal memory or the card contains
no pictures.
Record pictures.
r
PICTURE ERROR
There is a problem with the
selected picture and it
cannot be played back on
this camera.
Use image processing software to view the
picture on a computer. If that cannot be
done, the image file is damaged.
r
THE IMAGE
CANNOT BE
EDITED
Pictures taken by other
cameras, or previously
edited or corrected pictures
cannot be edited or fixed.
Use image processing software to edit the
pictures.
CARD-COVER
OPEN
The battery compartment/
card cover is open.
Close the battery compartment/card cover.
g
BATTERY EMPTY
The battery is empty.
Charge the battery.
This card cannot be used in
this camera, or, the card is
not formatted.
Format the card or replace.
• Select [POWER OFF] and press
o.
Insert a new card.
• Select [FORMAT]
[YES] and press
o.
All data on the card is erased.
There is an error in the
internal memory.
Select [MEMORY FORMAT]
[YES] and
press
o. All data in the internal memory is
erased.
NO CONNECTION
The camera is not connected
to the printer correctly.
Disconnect the camera and connect it again
correctly.
NO PAPER
There is no paper in the
printer.
Load some paper in the printer.
OK
SET
C A R D S E T U P
POWER OFF
FORMAT
OK
SET
M E M O RY S E T U P
POWER OFF
MEMORY FORMAT
[ I N ]