Olympus UFL-2 - Manual (Page 23)

EN 23
EN
5. Basic Shooting
Turning on the electronic flash
Connect the flash to the camera’s underwater case using a cable. After
turning on the camera and flash, be sure to check the remaining battery
power.
1 Press the POWER button.
• The control panel is displayed and battery charging starts.
• Press the POWER button again to turn the electronic flash off.
2 Verify that the CHARGE lamp lights up.
• Replace the batteries if the time it takes for the CHARGE lamp to
light up exceeds the following values.
• If the CHARGE lamp and AUTO CHECK lamp blink simultaneously,
it means that the battery capacity is running low. In this case,
replace the batteries.
3 Press the TEST button to test the flash activation.
Alkaline or oxyride batteries 30 sec. or more
NiMH or lithium batteries 10 sec. or more
AUTO CHECK lamp
TEST button/
CHARGE lamp
Control panel
POWER button
r2090_e_00.book Page 23 Thursday, May 1, 2008 6:29 PM