Olympus UFL-2 User Manual

Page 9

Advertising
background image

EN 9

EN

• Places where there are open fires.
• Places where water is deeper than 60 m.
• Places subject to vibrations.
• Places where high temperatures exist or high humidity and/or where

extreme differences in temperatures exist.

• Places where volatile chemicals are stored or used.

z

Do not apply excessive force on the arm mount.

z

In order to prevent the flash from overheating and losing quality, after
using the flash consecutively on full power, stop after 10 times for a
period of 10 minutes and allow the flash to cool down.

z

When this product is not used for a long time, the O-ring may deteriorate,
diminishing its waterproof properties. Please check the O-ring before use.

z

Do not use the following chemicals for cleaning, corrosion prevention,
prevention of fogging, repair or other purposes. When these are used
for the flash directly or indirectly (with the chemicals in vaporized state),
they may cause cracking or other problems.

z

Do not perform operations other than specified in this instruction
manual, do not remove or modify parts other than specified, and do not
use parts other than specified.
Any troubles in taking pictures or with the equipment resulting from the
above actions shall be outside the guarantee.

Chemicals which cannot

be used

Explanation

Volatile organic solvents,
chemical detergents

Do not clean the flash with alcohol, gasoline,
thinner or other volatile organic solvents or with
chemical detergents etc. Pure water or lukewarm
water is sufficient.

Anticorrosion agent

Do not use anticorrosion agents. The metal parts
use stainless steel or brass, and washing with
pure water is sufficient.

Adhesive

Do not use adhesive for repairs or other purposes.
When repair is required, please contact your local
service station or dealer.

r2090_e_00.book Page 9 Thursday, May 1, 2008 6:29 PM

Advertising