Pioneer XW-SMA3-W - Manual (Page 13)

Connections 02
13
En
Plugging in
After you’ve finished making all connections, plug the unit
into an AC outlet.
Important
• Before making or changing the connections, switch off
the power and disconnect the power cord from the AC
outlet.
When turning on this unit for the first
time
1 Open the terminal cover (XW-SMA3 only).
2 Plug the supplied AC adapter into the DC IN
socket on the rear of the unit.
3 Plug the supplied power cord into the AC
adapter then plug the other end into an AC
outlet.
4 Press  standby/on button.
5 The on indicator will flash for about 30 to 40
seconds. After about 30 to 40 seconds, the on
indicator will light blue.
Important
When using the built-in battery (XW-SMA3 only)
• Be sure to charge XW-SMA3 before using for the first
time.
• Approximately 3 hours are required to fully recharge the
battery.
• A fully charged battery provides approximately 4 hours of
use at maximum volume and approximately 6 hours at
50 % volume.
• Playing time with a fully charged battery changes
depending on functions used, frequency of use, ambient
temperature, speaker volume and other factors.
• The furnished battery can be recharged about 300 times,
although it may be less depending on conditions of use
and storage.
• When the AC adapter is not connected, the battery will
slowly drain even when the unit is in the standby mode.
As a result, if the unit is not used for an extended period
of time, recharging may be necessary before the unit can
be used again.
Warning
• Do not use any AC adapter other than the supplied unit,
since fire or shock may occur.
• The supplied AC adapter is designed exclusively for use
with this unit. Never attempt to use it with any device for
which it was not expressly designed, since fires or
shocks may occur.
• Do not use any power cord other than the one supplied
with this unit.
• Do not use the supplied power cord for any purpose
other than this unit.
• Ambient temperature when recharging the battery
should be between 5 ºC and 35 ºC. Outside this range of
temperatures, the battery protection circuit may operate,
preventing recharging.
AUX IN DC IN
To AC outlet
AC adapter
(supplied)
Power cord (supplied)
About startup time
About 30 seconds are required between after the power
turns On until the unit is actually ready to use. The time
required for startup can be reduced by setting the Quick
Start Mode to On (page 35).