Brocade Communications Systems ServerIron ADX 12.4.00a - Manual (Page 54)

40 ServerIron ADX Security Guide
53-1002440-03
Traffic segmentation
1
The contents of the display are defined in the following table.
You can use the show vlan-bridge command to show all of the bridged VLANs as follows.
ServerIron# show vlan-bridge
IN-VLAN Bridge VLAN
222 333
333 222
Syntax: show vlan-bridge
The contents of the display are defined in the following table.
TABLE 2 Display from show vlan command
This field... Displays...
PORT-VLAN The VLAN ID of the PORT VLAN configured.
Bridge VLAN The VLAN ID of the associated bridge VLAN.
Name The name of the VLAN as configured. If no name is configured, “{None]” is
displayed
Priority level The QoS priority as configured. If no priority value is configured the value
displayed will be “0”.
Spanning tree Displays the value of spanning tree protocol on this VLAN. Values can be “On”
or “Off”.
Untagged Ports Displays the untagged port members of the VLAN.
Tagged Ports Displays the tagged port members of the VLAN.
Uplink Ports Displays the uplink port members of the VLAN.
DualMode Ports Displays the port members of the VLAN that are in dual mode.
TABLE 3 Display from show vlan-bridge command
This field... Displays...
IN-VLAN The VLAN ID of the PORT VLAN configured.
Bridge VLAN The VLAN ID of the associated bridge VLAN.