1 before you start, Checking what’s in the box, Using this manual – Pioneer CT-L77 User Manual

Page 5: Putting the battery in the remote, Using the remote control

Advertising
background image

1 Before You Start

5

Checking What’s in the Box

Thank you for buying this Pioneer product. Before starting to set up your new stereo
system, please check that you received the following supplied accessories in the
XC–L77 Stereo CD Receiver box:

• AM loop antenna

• FM wire antenna

• Power cable

• Display unit connecting cable

• Lithium battery CR2025

(for remote control)

• Warranty card

• This instruction manual

In the box that the speakers came in you should find the following accessories:

• Subwoofer connecting cable

• Speaker cables (x2)

• Speaker stands (x2)

• Screws (x4)

(to attach speaker stands)

• Non skid pads (for satellite speakers (x8), for subwoofer (x4))

Using this manual

This manual is for the XC–L77 Stereo CD Receiver, CT–L77 Stereo Cassette Deck and
S–L8/S–L9/S–L9-A speaker system. It is split into two broad sections; the first covers
setting up, and the second, using the system. Set up, which starts here, shows you how
to install and connect up the system.

In the second section of the manual, starting on page 13, you’ll learn how to use every
feature of the CD receiver/cassette deck system. The final part of the manual provides a
troubleshooting section and technical specifications.

Putting the battery in the remote

1 Turn over the remote control. Push a ball-point pen into the hole to release

the battery cover and slide it off.

2 Put in the supplied battery, taking care to match the plus and minus sides

with the markings inside the compartment.

3 Slide the cover back on, and your remote is ready for use.

CAUTION:

Remove the battery if the remote is not going to be used for a month or more.

• Remove dead batteries promptly— they can leak and damage the unit.

• If the remote is connected to the display, no battery is necessary for it to work.

The battery is not recharged by connecting the remote to the display, however.

Using the remote control

Keep in mind the following when using the remote control unit:

• Make sure that there are no obstacles in between the remote and the remote

sensor on the unit.

• Use within the operating range and angle, as shown in the diagram left.

• Remote operation may become unreliable if strong sunlight or fluorescent

light is shining on the unit’s remote sensor.

• Remote controllers for different devices can interfere with each other. Avoid

using remotes for other equipment located nearby this unit.

• Replace the battery when you notice the operating range of the remote fall.

• On the rear of the remote there is a gold-coloured connector that links the

remote with the display unit. Avoid touching this when using the remote
separately.

Operating range of the remote
control unit

30

o

30

o

1

2

3

CAUTION

Danger of explosion if battery is incor-
rectly replaced.

Replace only with the same or
equivalent type recommended by the
manufacturer. Discard used batteries
according to the manufacturer’s
instructions.

7 meters

Advertising