Pioneer DDJ-WeGO2 - Manual (Page 13)

En 13
Basic
Operation
Monitoring sound with headphones
( rC)
1 Connect headphones to the [PHONES] terminal.
2 Press the [CUE ] button for the deck you want to
monitor.
3 Turn the [HEADPHONES MIX] control.
! Turn counterclockwise: The volume of the deck whose [CUE ] but-
ton is pressed increases relatively.
! Turn clockwise: The [MASTER OUT] volume increases relatively.
4 Turn the [HEADPHONES VOL] control.
! The sound of the deck whose [CUE ] button is pressed is output
from the headphones.
! When the [CUE ] button is pressed again, monitoring is canceled.
Mixing ( rB, D)
1 Operate the [TEMPO] slider to match the playing
speed on one deck to the playing speed on the other
deck.
— Move towards the + (front) side: The playing speed increases.
— Move towards the – (back) side: The playing speed decreases.
2 If the beats of the two decks are off, use the jog dial’s
pitch bend function to correct for this offset.
The playing speed can be adjusted by turning the outer part of the jog
dial during playback.
— Spin clockwise: The playing speed increases.
— Spin counterclockwise: The playing speed decreases.
— Stop spinning: Playback at the normal speed resumes.
! When the [SYNC (MASTER)] button is pressed, the two decks
are automatically set to the same playing speed. (The playing
speed is set to the speed of the deck selected as the master for
synchronization.)
3 Operate the channel faders or crossfader to mix the
sound of the two decks and switch between them.
Notes
! If the beats of the two decks do not match, the jog dial of the deck
selected as the master for synchronization lights in the set illumina-
tion color and the jog dial of the other deck is off.
! Once the beats of the two decks are matched, both jog dials light in
the set illumination color.
For the illumination color setting, see Changing the color of the jog
dial’s illumination (
rF) on page 14.
Inputting the sound of the
microphone
The sound of the microphone connected to the [MIC] terminal can be
mixed.
1 Connect the microphone to the [MIC] terminal.
2 Adjust the audio level input to the [MIC] terminal.
! Turn the [MIC VOL] control: The [MIC] terminal’s input audio level is
adjusted.
! Only the volume of the microphone’s sound can be adjusted.
! The sound of the microphone is not output from the headphones.
Quitting the system
1 Quit VIRTUAL DJ LE.
2 Slide this unit’s [ON/OFF] switch to the [OFF] position.
3 Disconnect the USB cable from your computer.