Pioneer MVH-350BT - Manual (Page 16)

2 Install the microphone clip on the steer-
ing column.
2
1
3
1 Double-sided tape
2 Install the microphone clip on the rear side of
the steering column.
3 Clamp
Use separately sold clamps to secure the
lead where necessary inside the vehicle.
Adjusting the microphone angle
The microphone angle can be adjusted.
Troubleshooting
Symptom Cause Action
The display
automatically
returns to the
ordinary dis-
play. You did not per-
form any opera-
tion within
about 30 sec-
onds. Perform operation
again.
The repeat
play range
changes un-
expectedly. Depending on
the repeat play
range, the se-
lected range
may change
when another
folder or track is
being selected
or during fast
forwarding/re-
versing. Select the repeat
play range again.
A subfolder is
not played
back. Subfolders can-
not be played
when
FLD (fold-
er repeat) is se-
lected.
Select another re-
peat play range.
NO XXXX ap-
pears when a
display is
changed (
NO
TITLE, for ex-
ample).
There is no em-
bedded text in-
formation. Switch the display
or play another
track/file.
The unit is
malfunction-
ing.
There is inter-
ference. You are using a
device, such as
a cellular
phone, that
transmits elec-
tric waves near
the unit. Move electrical
devices that may
be causing the in-
terference away
from the unit.
Symptom Cause Action
The sound
from the
Bluetooth
audio source
is not played
back. There is a call in
progress on a
Bluetooth con-
nected cellular
phone. The sound will be
played back when
the call is termi-
nated.
A Bluetooth
connected cel-
lular phone is
currently being
operated. Do not operate
the cellular phone
at this time.
A call was
made with a
Bluetooth con-
nected cellular
phone and then
immediately ter-
minated. As a
result, commu-
nication be-
tween this unit
and the cellular
phone was not
terminated
properly. Reconnect the
Bluetooth con-
nection between
this unit and the
cellular phone.
Error messages
When you contact your dealer or your nearest
Pioneer Service Center, be sure to note the error
message.
Installation
16
Section
Additional information
En
03